Search resources

This application note describes Firmware modifications implemented to make the HL6528x embedded module resistant to power outages during a FOTA upgrade, and explains how users can make their devices more robust against power outages.

This document describes the features and specifications of the AirPrime SL809x 3G module and provides you with the information required to integrate the SL809x into your products.

This article lists the networks that are available/certified for the following devices: GX/ES440, GX/ES450, LX60 and RV50/RV50X.

This article provides information regarding entry of an APN for the GX, ES, LS, LX and RV device series. 

This article explains when a SIM card is necessary for various AirLink devices and how a static IP can be obtained. 

This article explains the purpose of the additional antenna port on the following AirLink Gateways: GX400, GX/ES440, GX/ES450, LS300, and RV50.

This article provides information regarding IPv6.

This article provides instructions for configuring an AirLink GX400, GX/ES440, GX/ES450, LS300, LX60 or RV50/RV50X and a Cisco 881 router for WAN Failover.

This article describes how to configure and send SMS commands using an AirLink device.

This article provides pinouts and diagrams for the DC power cord used with the LS300 and GX Series modems.

Lists the Garmin GPS devices that are supported by the Nav application.

This article describes the hardware and configuration settings necessary to establish a Reverse SSH to a Serial Device behind an AirLink device.

Latest HL6528RDx Firmware

This article provides the configuration guide for using the Philips MRx Application Module with an oMG.

This document aims to provide a guideline for designing applications based on the AirPrime SL Series. Recommendations are provided to maximize the compatibility between the modules when using different variants of the SL series for the same application.

This article provides a guide on configurig the ZOLL RescueNet Navigator for use with the oMG.

This article provides a configuration guide for using the ZOLL E Series Application Module on an oMG.

This article provides a document describing how to replace the internal fuse in an oMG.

This article provides the guide for installing PEM modules into an oMG.

This article provides a document detailing how to replace a power connector on the oMG.