This application note describes the Dual SIM Single Standby feature of the AirPrime HL Series of embedded modules.

This document provides a brief introduction of 3GPP advanced power saving features like PSM and eDRX, and explains how to test these features.

The MangOH Red board does not come with a standard DB9 serial port like some of the other development boards and so the purpose of this document is to describe the necessary circuitry to interface a USB-to-Serial/RS-232 adapter/cable to the MangOH Red’s Raspberry Pi UART interface. The necessary components are widely available, and this interface will work with either the AirPrime HL and WP Series embedded modules.

This document describes the Secure Debug feature that is enabled on Secure Boot-enabled devices.

Contains a document explaining how to set up the FX30/FX30S to act as a Wi-Fi client or access point using the Mirage IoT Card from Talon Communications.

This document describes the antenna diagnosis feature of the AirPrime WP module.

This document helps users visually identify the location of Pin 1 on AirPrime XA modules.

This document describes raw GNSS data message content.

This application note explains the details of BootROM with BROM.DLL handshaking and flash download / format process and helps users upgrade firmware images that can be sent to a target (GNSS module) via the RS232 (UART) interface via their hosts.

This document explains how to use the GNSS Android driver sample code to integrate Android 7.0 into AirPrime XA and XM modules.

This application note describes the antenna detection feature of the AirPrime HL Series of embedded modules.

This document explains the FW, Linux QMI driver and Linux QMI SDK based host application updates needed to support multiple PDNs over a single USB RMNET interface.

This application note explains in detail Sprint's OMA polling functionality. The OMA Polling function is required for M2M and PC-based devices to attempt to connect to the Sprint OMA server at regular intervals to check for and download updates, if available.

The HL7588 embedded module supports dedicated data bearer in the firmware. This technical note describes how to enable dedicated bearer via the appropriate use of supporting AT commands.

This technical note explains how a Java application can be run on an AirPrime AR/WP embedded module and how it can use Legato APIs to perform embedded module operations.

The Sierra Wireless AirPrime HL75xx and HL76xx modules support different power management options (sleep modes) over UART. It is imperative for the host applications to understand these power management options and exercise these options as per the platform needs.

Provides an application note listing the capacitors and inductors in the BC127.

This document describes the steps needed to rework the AirPrime BC127 and set it up for conducted RF tests.

This application note provides all necessary information to perform Firmware Over-The-Air (FOTA) and Software Over-The-Air (SOTA) on Sierra Wireless AirPrime WP Series modules. This application note applies to all products in the AirPrime WP8 and WP7 Series.

The Sierra Wireless MDM9X15 and MDM9X30 family of modems support carrier switching. This is a feature where the same modem can be used with different carriers from different geographies by downloading and activating the correct FW package for the carrier and modem. This document explains how customers can match a FW package with the correct supported modem.